Glade® Clean Linen Sense and Spray Automatic Freshener

Glade
From
Add to cart
  • Description
  • More

Glade® Sense & Spray® Automatic Freshener is equipped with motion sensor technology - detects when you pass and instantly release the fresh cent of line-dried laundry into the air.  It is economical as it automatically freshens only when you it most.

It conserve refill as you can enter a 15, 20 or 30 minute lockout mode after initial motion is detected. After lockout mode, Glade® Sense & Spray® Automatic Freshener automatically enters Inchactive Inch mode to seek motion for the next spray.

Glade Sense & Spray features a boost button for manual activation and control to provide instant and additional freshness at your desire.

Glade® Sense & Spray® Automatic Freshener Clean Unit Kit includes 1 Automatic Spray Unit, 1 12g Mini-Aerosol, 2 AA Batteries.

DIRECTION FOR USE:

Operation:

The smart unit automatically sprays fragrance when it has detected motion or a shadow has been cast upon a sensor.
To conserve the refill, the unit automatically enters a 20 minute lock-out mode, during which time the sensors are off and the unit will not automatically spray. After the lockout mode time has expired, the unit is again ready to sense motion.

For an instant burst of Glade® fragrance anytime, press the boost button on the top of the unit.
Use only Glade® Sense & Spray® refills in this unit.

Positioning:

For best results, place unit upright on a flat surface where upward spray will not be obstructed. Place unit within 1.5 m of traffic flow.

Helpful hints:

The sensor may not respond if:

The room is too dark. Ensure there's sufficient lighting to allow a shadow to be cast upon sensor.

The unit is placed directly on or in a light source, especially sunlight. Move the unit out of the bright light.

Sensor on the front of the device is blocked by objects. Position the unit so that the sensor is unobstructed.

CAUTION:

Keep the unit pointed away from you and others during assembly. It automatically sprays a burst of fragrance after assembly to show it is working properly.

Assembly:

Sense & Spray

Lift front cover. Place canister in position over the tan coloured tab. Snap canister into place. You will hear a click to know the refill has been inserted correctly.

Pull and discard red tab to activate batteries.

To replace canister, lift front cover and remove the empty canister. To install new canister, follow assembly instructions above

To replace batteries, lift front cover. Insert two new AA batteries.

NOTE: Be sure that replacement batteries are positioned correctly. Unit will not function if batteries are installed backward.

DOWNLOAD GLADE SENSE SPRAY AUTOMATIC AIR FRESHENER MSDS