Actichem Solve Sealer Gold Solvent Based Tile and Stone Sealer

Add to cart
  • Description
  • More

Actichem's Solv Sealer Gold is a professionally formulated solvent based penetrating sealer providing exceptional protection for porcelain,low porosity tiles and fine stone. It provides up to 15 years of premium protection. It does not alter the natural look of fine stone nor change its surface.

Suggested Applications:

Formulated to provide ultimate protection from staining to all forms of fine stone, masonry and cementitious surfaces including:

Granite, marble, limestone, travertine. (Polished, honed, exfoliated, flamed or saw cut)
Basalt and Bluestone
Terracotta, Saltillo, Quarry and Terrazzo.
Sandstone and Slate.
Masonry and concrete.

It is based on “ultra-small molecule structure” technology which enables it to penetrate into the fine pores of polished porcelain, dense granite and fine stone to create a high performance sub-surface barrier against water and oil borne contamination. Available in 500ml, 5 and 15 liters.

It is perfect for both indoor and outdoor. It won't trap moisture. It allows natural stone to "breathe." It will not etch or cause discolouration of polished marble and fine stone surfaces and it will not alter the appearance or texture of its surface.


New installations must be fully cured before application of Solv Sealer Gold (Min 48 hours)
Existing stone, tile and grout must be totally clean, dry and chemical free.
Coverage is 5 to 25m2 / Litre per coat.
Do not apply in direct sunlight. Temperature must be between 10°C and 28°C.
Highly absorbent surfaces may require two or three coats.
Apply 1 to 3 coats of Solv Sealer Gold by generously saturating the surface using a polish applicator, roller or sprayer to an area which can be easily reached. (Approximately 15m2). Ensure even coverage.
The surface must be shiny wet with a liquid film for at least 1 minute. For very porous substrates more sealer may need to be applied.
Allow 5 – 10 minutes for the sealer to absorb into the surface and then move the excess product with a squeegee to a new section.
If a second coat is to be applied, wait 20 to 30 minutes and repeat the process.
Using absorbent toweling or applicator, wipe off any sealer remaining on the surface after 10 minutes of the last application. Moisten the towel with Methylated Spirits to remove residues which have dried on the surface.
Allow 12 hours before returning area to traffic. Keep dry for 24 hours. Achieves a full cure in 24-48 hours.


Flammable according to the criteria of ADG.
Hazardous according to the criteria of NOHSC.
Read and understand the Material Safety Data Sheet before opening.
Solv Sealer Gold has been performance tested by Stone Initiatives Pty Ltd; an independent ASTM listed, ASAA member Dimension Stone Laboratory to assess the stain resistance imparted to applied surfaces.