To achieve the best possible finish for your glass, you must clean the surface thoroughly and dry it before applying Vitroglaze. Here's how:
For New Glass:
STEP 1. Apply the Foaming Pre-Cleaner to the glass surface (shake well before use) and using a clean, dry rag or paper towel rub over the surface until the glass is streak free and dry.
STEP 2. Apply the Vitroglaze evenly to a small area of the cleaned glass surface (about 1 square metre at a time) and immediately wipe over this area using a clean flat folded piece of paper towel or rag. Continue this process until all the glass surfaces have been treated.
STEP 3. Using a clean dry rag or paper towel, rub over the entire glass areas for about 1 minute to achieve a sparkling finish.
For glass treatment that’s not brand new:
Simply clean the glass as you normally would then using a mild detergent in warm water and the hand scourer provided, rub vigorously over the entire glass surface. Dry the entire surface then proceed with the application from step 1-3.
Allow to cure for 24 hours before glass comes in contact with water.