Satin Star Floor Sealer 5L and 15L - Research Products

Add to cart
  • Description
  • More

Satin finish for most surfaces with great wear ability and chemical resistance. Commercial vinyl-preseal with Bedrock.

Other floor surfaces no need to pre-seal, apply two to five coats depending on depth of gloss required.

Satin Star has been formulated to give a satin finish to most surfaces with great wear ability and chemical resistance.

Directions for use

(See How to Manual for details on most floor surfaces.) Terrazzo, concrete, marble and other porous stone surfaces: Always pre-seal with Blockade or Bedrock for maximum adhesion and chemical resistance. Commercial vinyl tiles: Pre-seal with Bedrock. All other floor surfaces: No need to pre-seal, apply two to five coats, depending on depth of gloss preferred.


The best performance level as an anti-stain is reached after a 24-hour curing period. Do not vitrify the surface until curing has taken effect, however, it is safe to apply surface coatings after 8 hours. Try to keep traffic and staining materials away from the surface for 24 hours if possible.

Dry/Recoat time: 15 – 45 mins (All depending on weather conditions).
Walk on (light foot traffic) : approximately 1 hour.
Replace furniture: approximately 8 hours.
Normally cures in 24 hours.


Use either Supastar or Neutraclean as per label.


Use either Neutraclean or Shiner for maximum wearability.

First Aid

Skin: Remove contaminated clothing. Flush with fresh water.
Eyes: Flush eyes with water for 15 minutes while keeping eyelids open. Seek medical advice.
Inhalation: Remove patient to fresh air.

Click here to download the Material Safety Data Sheet