Dazzler Timber Floor Sealer - Research Products

Research Products
Add to cart
  • Description
  • More

Polyurethane fortified sealer finish for timber and cork floors. Long wearing tough finish. Safe at Any Speed 300 to 2000+ RPM

Here’s the first floor finish in Australia developed to give all contract cleaners the ultimate result on timber and cork floors, with any type of maintenance equipment - even 2000 RPM Glazers, electrics, LP Gas or battery powered.

RESEARCH PRODUCTS water borne fortified polyurethane technology has provided the key to longer wearing, tougher and more easily maintained floor than ever before possible with less scuffing and marking.

DAZZLER is the culmination of years of effort to produce the most wear resistant; easily maintained, scrubable floors that repeatedly buff to a clean and shiny look day after day, under extreme traffic conditions.

You’ve Never Seen Floors Needing Less Maintenance

The polyurethane film layer on the floor is thermo elastic and softens when heated by super speed buffing to leave a wet look gloss that resists black marks and sheds dirt and grime.

This thermo elastic film is just like a sheet of “glad wrap” protecting your floor, yet it can be removed by normal techniques and maintained by normal techniques.

Most Commonly Asked Questions:

Where can DAZZLER be used?
All heavy traffic areas like shopping malls, dance floors, hospitals, Nursing Homes, office buildings and supermarkets. In fact on any pretreated timber floor, except spirit based waxes.


For best results floor should be stripped of old finish. However DAZZLER may be applied over conventional finish in good condition with just a blue pad cut-back using NEUTRACLEAN or SUPASTAR. Rinse with cold to warm water.

Application on New Floors

Presealed floor with either Tung Oil or Daylight Express (see separate data sheet). Use only clean polish mops for application, apply thin even coats. Apply up to four coats depending on the result required. Allow at least 1/2 hour between coats, longer in cold weather.


Dust mop daily - tracked in sand and grit destroys all floor finishes. Damp mop or autoscrub using SUPASTAR. Dry burnish or spraybuff using either SHINER with conventional swing polishers or REBOUND with high speed or super speed machinery.


Just cut back with a blue pad and NEUTRACLEAN 1 to 20 parts water, rinse and recoat traffic lanes. Never apply DAZZLER to a dirty floor.


SLEDGEHAMMER stripper is the perfect all round effective stripper for DAZZLER.

Click here to download the Dazzler Material Safety Data Sheet