To fully stripped floors apply 1-2 coats of AQUASEAL Semi-Permanent Sealer to fill and prepare the floor surface. After this procedure apply 2 or 3 coats of MERIDIAN High Performance Floor Finish,allowing sufficient drying time between coats. Ongoing maintenance requires application of MERIDIAN at intervals in accordance with traffic volumes.
Apply MERIDIAN with a clean cotton mop or polish applicator. Allow each coat to dry before application of further coats. Old or discoloured polish should be stripped from t
he floor with LAZER SUPER Floor Stripper.
To retain a clean gloss floor, provide daily maintenance using an approved system incorporating Peerless Pro Products and Equipment.
MAINTENANCE: Dust Mop Daily. Wet clean as required using Versadet Neutral Cleaner in accordance with label directions. Clean with Auto Scrubber or by Manual Mopping. Clean the floor surface and allow drying – Rinsing is not required. Burnish MERIDIAN High Performance Floor Finish with Propane, Battery or Electric Polishing Machine equipped with Burnishing Pad.
PERIODIC RESTORATION: A regular cutback and recoat system will extend the overall appearance of the floor. The cutback procedure is affected using a higher concentration of Versadet Neutral Cleaner in the Auto Scrubber and Blue Scrubbing Pads on the Machine. Scrub the entire floor area with Auto Scrubber. Pick up dirty solution. Detail edges and corners. Rinse and Burnish. The floor should be inspected to ensure the surface is clean and ready for re-application of MERIDIAN High Performance Floor Finish as detailed above.
Eyes: If splashed in eyes, flush with water for 15min. Seek medical advice.
Skin: Wash affected area with soap and water.
Inhalation: If mists are inhaled, remove patient to fresh air. Seek medical advice.
Swallowed: Do NOT induce vomiting. Give milk or water to dilute. Seek medical advice
Download Meridian Floor Finish MSDS